You should also search the shipping examples. Go to the Instrument Driver Network , click the search link, enter A, and download the driver. It is an autobalancing bridge, which provides remarkable wide range and accuracy, from Hz to MHz. A driver would have all of the instruments commands necessary to communicate with it. Drivers are available here. I don’t have the instrument’s manual, or even the instrument, anymore. You only see data for one marker at a time, even though two are displayed.
|Date Added:||26 February 2004|
|File Size:||53.33 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
I have version 1. Unzip the file and run setup.
Agilent Technologies / Keysight Technologies 4194A
WHat i do now is once i am done with the frequency sweep, I have to note down the readings by hand which is very time consuming. Message 3 of This is done in the left-side column. Will keep you posted after trying it with the instrument. Here is an example. Labvieww the “add file” button next to the Data File box and specify where you want the.
HP a Analyzer LabView Libraries?
Message 8 of A driver would have all of the instruments commands necessary to communicate with it. Message 10 of I am glad I found this thread with your example vi’s for the HP A.
Min, max, center, and span are not very helpful. With this one, you can get specific readings, up4194a the whole sweep. Then, when you request array A data, it will be the raw measurements for your sweep set up.
Please let me know. Go to the Instrument Driver Networkclick the search link, enter A, and download the driver. They are available at no charge as labiew as you don’t specify support for an NI product.
You only see data for one marker at a time, even though two are displayed. Lbaview are you running your tests, and what parameters are you reading?
Agilent Analyzer – IEEE (GPIB) Driver for LabVIEW – National Instruments
The raw data will also be available in the Data File you specified. All you need to do is click Capture. Download Plot from here. You should also search the shipping examples. Here are a few more examples click to see full resolution: When you double-click on Plot.
Most Active Hardware Boards: It also saves the raw data from labvuew as a. Create a folder for your plot processing and put these files in it. Change those parameters to get what you want. I can do all the calibration and settings from the front panel.
I either sent the online commands for the tests, or ran a stored program and had it return the data. I suggest that you become familiar with the parameters that are available to use.
Pretty ugly, isn’t it? It’s hard h;4194a get your bearings — where are the axis and tick mark labels?
My program does a cap sweep.